catalogue

View Cart | Checkout | Items:, Value:

spacer
spacer

Best Sellers

O ring, Thermostat base, and water pump

O ring, Thermostat base, and water pump


A replacement O ring which fits the base of the thermostat housing where it sits on the rear manifold, and also where the metal pipe bolts into the water pump.

find out more

2.21

Airbox-carb rubber duct carbs 2 & 4

Airbox-carb rubber duct carbs 2 & 4



The inlet rubbers between the airfilter box and carburettors harden over time, and quickly become impossible to re-fit due to being too stiff.

This is a single replacement model specific inlet rubber which will fit either number 2 or number 4 carburettor. (900R,1000RX & 750R)

Remember that you will need to order two, as they are sold singly.

(The GPZ 600R and 750A use the same inlet rubber for all 4 carburettors)

find out more

11.76

Thermostat Housing O Ring

Thermostat Housing O Ring


The O ring that seals the two thermostat housing halves. Choose from Aftermarket or Kawasaki O.E. the aftermarket O ring has been manufactured to o/e specifications on our behalf.

find out more

2.40

spacer

New additions

Gasket - Fuel sender

Gasket - Fuel sender


A replacement gasket for the GPZ 900R's fuel guage sender unit, supplied with screws.

find out more

10.67

Emergency use sidestand switch bypass

Emergency use sidestand switch bypass


The GPZ 900R's sidestand switch is an integral and very important part of the ignition system and should it fail, you run the risk of being left at the side of the road.

This is an emergency bypass connector for the sidestand switch in the event of it failing. Simply unplug the defective sidestand switch and plug in this connector, this will then provide an earth for the CDI unit. It can also be used as a diagnostic aid to isolate the sidestand switch if it is suspected of causing a misfire or irregular running.

It is highly recommended to supplement your underseat tool-kit and is intended to be used as an emergency, "get you home" measure.

SAFETY WARNING- The sidestand warning light does not work whilst this is fitted.

find out more

4.99

spacer

GPZ 900R Model identification

The GPZ 900R was available in the UK from 1984 through to 1992.

A small number of A8 models were imported in 1997-98.

Untitled Document

Model
Frame Number
Year
Comments
GPZ 900R A1 ZX900A-000011 - 0150001984Single throttle cable
GPZ 900R A2 ZX900A-015000 - 0310001985 
GPZ 900R A3 ZX900A-031001 - 0351001986Twin throttle cables
GPZ 900R A4 ZX900A-035101 - 0385001987 
GPZ 900R A5 ZX900A-038501 - 042001 1988 
GPZ 900R A6 ZX900A-042001 - 048001 1989 
GPZ 900R A7 ZX900A-048001 - 056000199017" Front wheel
GPZ 900R A8ZX900A-056001 - -0680011991 
GPZ 900R A8-> ZX900A-068001 - 9999991991-> 
spacer
spacer