catalogue

View Cart | Checkout | Items:, Value:

spacer
spacer

Best Sellers

O ring, Thermostat base, and water pump

O ring, Thermostat base, and water pump


A replacement O ring which fits the base of the thermostat housing where it sits on the rear manifold, and also where the metal pipe bolts into the water pump.

find out more

2.21

Airbox-carb rubber duct carbs 2 & 4

Airbox-carb rubber duct carbs 2 & 4



The inlet rubbers between the airfilter box and carburettors harden over time, and quickly become impossible to re-fit due to being too stiff.

This is a single replacement model specific inlet rubber which will fit either number 2 or number 4 carburettor. (900R,1000RX & 750R)

Remember that you will need to order two, as they are sold singly.

(The GPZ 600R and 750A use the same inlet rubber for all 4 carburettors)

find out more

11.76

Thermostat Housing O Ring

Thermostat Housing O Ring


The O ring that seals the two thermostat housing halves. Choose from Aftermarket or Kawasaki O.E. the aftermarket O ring has been manufactured to o/e specifications on our behalf.

find out more

2.40

spacer

New additions

Gasket - Fuel sender

Gasket - Fuel sender


A replacement gasket for the GPZ 900R's fuel guage sender unit, supplied with screws.

find out more

10.67

Emergency use sidestand switch bypass

Emergency use sidestand switch bypass


The GPZ 900R's sidestand switch is an integral and very important part of the ignition system and should it fail, you run the risk of being left at the side of the road.

This is an emergency bypass connector for the sidestand switch in the event of it failing. Simply unplug the defective sidestand switch and plug in this connector, this will then provide an earth for the CDI unit. It can also be used as a diagnostic aid to isolate the sidestand switch if it is suspected of causing a misfire or irregular running.

It is highly recommended to supplement your underseat tool-kit and is intended to be used as an emergency, "get you home" measure.

SAFETY WARNING- The sidestand warning light does not work whilst this is fitted.

find out more

4.99

spacer

GPZ 900R Tuning & Performance

catalogue | GPZ 900R spares |  GPZ 900R Tuning & Performance

S&B Individual AirfilterS&B Individual Airfilter

Realistically priced individual airfilters, which mount directly on to the rear of the carburettor. Sold singly, and ideal for stage 3 tuning.


Price Inc VAT: 15.95 (13.29 Excluding VAT at 20%)


Quantity:  

K&N Dual Flanged Aifilters

A pair of dual flanged airfilters from K&N, suitable for stage 3 tuning. These are popular due to their increased security when fitted, as one filter clamps directly on to the rear of 2 x carburettors.

*** Special Order only - Please call ***


Price Inc VAT: 106.82 (89.02 Excluding VAT at 20%)


Quantity:  



Related products:
1. Airfilter oil - K&N
K&N Dual Flanged Aifilters
K&N Individual AifiltersK&N Individual Aifilters

A set of 4 x 55mm Oval Clamp on individual Airfilters from K&N, suitable for stage 3 tuning. They clamp directly on to the rear of each of the carburettors once the airfilter box is removed.


Price Inc VAT: 160.80 (134.00 Excluding VAT at 20%)


Quantity:  



Related products:
1. Airfilter oil - K&N
Airfilter element K&N

This is a direct replacement for the standard airfilter found on all models of GPZ 900R. This replacement is suitable for stage 1 tuning, or indeed just use it to renew a tired original air filter. Anything with a 1,000,000 mile warranty can't be that bad!


Price Inc VAT: 55.94 (46.62 Excluding VAT at 20%)


Quantity:  



Related products:
1. Airfilter oil - K&N
Airfilter element K&N
Dynojet Kit A1-A6Dynojet Kit A1-A6

This kit from Dynojet enables owners to tune A1-A6 machines to either stage 1 (road), or stage 3 (race).

The kit contains replacement jets, needles, washers, clips and lighter slide springs. If tuning to stage 3, it will be necessary to remove the airfilter box, and fit individual air filters.


Price Inc VAT: 143.95 (119.96 Excluding VAT at 20%)


Quantity:  


People who bought this item also bought:
1. Clamp, Carburettor Holder (carb side)


Related products:
1. S&B Individual Airfilter
Dynojet Kit A7-A8

This kit from Dynojet enables owners to tune A7-A8 machines to stage 1 (road)

The kit contains replacement jets, needles, washers, clips and lighter slide springs.


Price Inc VAT: 143.95 (119.96 Excluding VAT at 20%)


Quantity:  



Related products:
1. S&B Individual Airfilter
Dynojet Kit A7-A8
JetJet

A Keihin main jet available in different sizes.

The factory standard on GPZ 900R A1-A6 models is 132.5, whilst on A7-A8 models it is 100. The standard on all models of GPZ 500S is 130.

Sizes increase / decrease in increments of 2.5.

Sold singly.

<More...>


Price Inc VAT: 1.94 (1.62 Excluding VAT at 20%)

Please choose size required


Quantity:  


People who bought this item also bought:
1. Vice soft jaws
Dynacoils - Pair

A pair of high output 2.2 ohm ignition coils. These bolt directly on to the existing mountings, and offer increased spark voltage. It is not possible to use existing HT leads with these coils, as the method of attachment is different, so we recommend Taylor HT leads for use with this product

*** Special Order only - Please call ***





Related products:
1. Taylor HT leads
Dynacoils - Pair
Taylor HT leadsTaylor HT leads

A set of 4 Taylor HT leads. generally accepted as the perfect partner for Dyna coils.

*** Special Order Only. Please call ***





Related products:
1. Dynacoils - Pair
Airfilter oil - K&N

A 335 ml aerosol can of airfilter oil specially formulated for use on K&N paper airfilters.

Shipping restriction - Cannot be shipped by air.


Price Inc VAT: 7.20 (6.00 Excluding VAT at 20%)


Quantity:  

Airfilter oil - K&N

catalogue | GPZ 900R spares |  GPZ 900R Tuning & Performance

spacer
spacer